GlobalVision Flatbed Scanner Desktop Inspection System with Monitor Arm

Note: Do not fully tighten any bolts until every part is assembled.


Instructions

The following instructions are to assemble the Flatbed scanner Table:

GlobalVision Flatbed Scanner Table Parts Assembly


Assembly Parts List

1

#

Part Name

Quantity

2

1

Right Leg

1

3

2

Left Leg

1

4

3

Horizontal Support Bar

1

5

4

Tabletop

1

6

5

Computer Tray

2

7

6

Bolts

14

8

7

T-Handle Allen key 3/16"

1

GlobalVision Flatbed Scanner Table Parts List


Step 1

Slide the Left Leg (Part #2) in the Horizontal Support Bar (Part #3), for (two) bolt entry points align with one another. Place and fasten the two bolts.

Attaching the Left Leg


Step 2

Slide the Right Leg (Part #1) in the Horizontal Support Bar (Part #3), for the (two) bolt entry points to align with one another. Place and fasten the two bolts.

Attaching the Right Leg


Step 3

Place the Tabletop (Part #4) on top of the two legs (Parts #1 and #2) by aligning it with the (four) bolt entry points on each side. Place and fasten the four bolts on each side.

Attaching the Table Top


Step 4

Connect the Computer Tray (Part #5) on the inside of the Right Leg (Part #2) so that its flat surface rests on the Horizontal Support Bar (Part #3) and for the (two) bolt entry points align with another set. Place and fasten the two bolts.

Connecting the Computer Tray


Step 5

Connect the Monitor Arm to the right side of the Right Leg (Part #1).

Note: Follow instructions with the Monitor Arm assembly guide.

Connecting the Monitor Arm


Step 6

Tighten all the bolts to ensure the Flatbed Scanner Table is safe and ready to use.


Assembly Guide PDF:

GlobalVision Flatbed Scanner Table Assembly Guide rev.002.pdf