Skip to main content
Skip table of contents

Roll Scanner Stand Assembly Guide

image-20240116-181957.png

GlobalVision Roll Scanner Desktop Inspection System


Instructions

The following instructions are to assemble the Roll scanner Stand:

Note: Do not fully tighten any bolts until all parts are assembled.

image-20240110-170252.png

GlobalVision Roll Scanner Assembly Parts


Parts List

#

Part Name

Quantity

1

Left Leg

1

2

Right Leg

1

3

Horizontal Support Bar

1

4

Front Tray

1

5

Front Diagonal Support Bar

2

6

Rear Tray

1

7

Computer Tray

1

8

Bolts

16

9

Allen key 3/16"

1

10

Electro-Static Ground plug

1

GlobalVision Roll Scanner Parts List


Step 1

Connect left leg assembly (Ref Table 1: Part #1) to horizontal support bar (Ref Table 1: Part #3) and attach with 2 bolts.

image-20240110-184817.png

Attaching left leg to horizontal support bar


Step 2

Connect right leg assembly (Part #2) to horizontal support bar (Part #3) and attach with 2 bolts.

image-20240116-182215.png

Attaching right leg to horizontal support bar


Step 3

Connect the front tray (Part #4) on top of the two legs (Parts #1 and 2) and attach with 2 bolts on each side.

image-20240116-182304.png

Connecting front tray with the two legs


Step 4

Connect the two left/right diagonal support bars (Part #5) for the front support tray (Part #4) by placing the support bar bottom end in the front leg socket and the top end under the front tray.

Attached is the bolt from the top of the front tray. Repeat for the second support bar.

Connecting two support bars with a front support tray


Step 5

Connect the rear tray (Part #6) on top of the two legs (Parts #1 and 2) and attach with 2 bolts on each side.

image-20240116-182344.png

Attaching rear tray with the two legs


Step 6

Connect the computer tray (Part #7) to the left side of the right leg under the scanner trays (Parts #4 and 6) by aligning the computer tray to the 2 bolt entry points. Attach the 2 bolts.

image-20240116-182422.png
image-20240116-182449.png

Attaching computer tray with right leg


Step 7

Connect the Monitor Arm to the right side of the right leg (Part #2).


Step 8

Ground the scanner stand by connecting the anti-static ground plug(Part #10) provided. The button, on the anti-static cable, will snap into the right scanner stand leg. Then, from the anti-static cable, plug the ground socket into a grounded power bar or wall socket.

Note: Follow instructions with the Monitor Arm assembly guide.

image-20240110-185058.png

Connecting the anti-static ground plug


Step 9

Tighten all the bolts to ensure that the stand is safe and ready to use.

image-20240116-182540.png

Finishing setup


Assembly Guide PDF:

GlobalVision Roll Scanner Table With Electro static Plug Assembly Guide (WIP) (2).pdf

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.